Recent content by scarab02

@tansfilippo - No issues whatsoever. As noted above, I did apply a Urethane clearcoat over the epoxy. Not sure that I would do the Urethane again, the clear takes quite a beating when you are dragging engine lifts/stands across the floor. The high wear areas show a little scuffing with the...

Zogman:: Regarding prep: I had a couple of nasty oil stains from the previous owner. Tried a concentrated mixture of Tide (mixed results) - the mixture removed a good deal of the stain but not all. To the fun stuff... muriatic acid. I did a 1 to 4 mixture of acid for the initial etch...

Long time lurker finally ready to post. :) After much reading, I decided that the Norklad 200 product w/the HPU747 clear would meet my needs. Final cost for this project was about $2.10/sqft (primer, epoxy, clear and some accessories). This is the second epoxy project I have completed; my...

Regarding the Norklad 200: I finished installing the same epoxy (w/HPU747 clearcoat) in my garage a few weeks ago. Here's my .02. 1. Wear a respirator. A paper dust mask (or similar) will not cut the fumes from the epoxy or the clear coat. Your local big box store has plenty of masks...

nokkieny - I just put down the HPU 747 last week on my garage floor. Just mix, squeegee and roll the urethane. If you haven't done it already... make sure that you wear an organic vapor respirator. The vapors from the urethane are absolutely the worst - but the clear coat is wonderful...