Recent content by scottb1469

  1. S

    good color to paint the garage

    I agree with you. Sent from my iPhone using Tapatalk
  2. S

    My new metal building

    Sent from my iPhone using Tapatalk
  3. S

    My new metal building

    I haven’t done a scientific evaluation on the heat reduction but here’s my seat of the pants opinion.... I live in SW Florida, it’s almost October and it’s still in the lower 90s with high humidity. The summer here is actually the rainy season. I read that the insulation on the roof panels does...
  4. S

    My new metal building

    I did an acid etch. I didn’t have to do anything with the cracks except fill them in with sand a little so I didn’t need as much filler. I used a grinding wheel to smooth any rough spots after it dried. The polyurea is awesome and I can’t recommend it enough. It’s super strong, stands up to...
  5. S

    My new metal building

    Precision Door Sent from my iPhone using Tapatalk
  6. S

    My new metal building

    Sent from my iPhone using Tapatalk
  7. S

    My new metal building

    Thanks guys! It’s been awhile but I’ve been busy. Insulated the walls with 1/2 radiant backed foam panels then put up 3/4 OSB, built some shelves, a bench and put up some cabinets. Just finished the paint last week.
  8. S

    My new metal building

    Garage door is in! CHI to FL code with impact glass. Jackshaft opener is next. Sent from my iPhone using Tapatalk
  9. S

    My new metal building

    Sent from my iPhone using Tapatalk
  10. S

    My new metal building

    https://www.garageflooringllc.com/polyurea-garage-floor-coating/ Sent from my iPhone using Tapatalk
  11. S

    My new metal building

    First coat of polyurea is down. Justin from garageflooringllc is great btw. Had a quick question before I got started so I texted him directly and he answered immediately. Great customer service. Just waiting until I can scrape/vacuum the flakes and roll on the clear top coat. Sent from my...
  12. S

    My new metal building

    Filled the concrete cuts with ArmorPoxy’s product. It mixes 1/1 and goes in like spackle. Ground down the edges with a grinder. Sent from my iPhone using Tapatalk
  13. S

    My new metal building

    10’ walls and it’s 12’7” at the center. I’m certain a lift could fit but I don’t have plans for one. Sent from my iPhone using Tapatalk
  14. S

    My new metal building

    So far my experience here in Florida has been good. I have a ******* Jeep and normally it collects condensation overnight on the seats and on the inside of the windshield. If I pull it into the garage it’s dry as a bone in the morning. Granted I don’t have a front overhead door yet but I’ll...
  15. S

    My new metal building

    The stamped engineering plans were from Carolina Carports. Sent from my iPhone using Tapatalk
See more
Top Bottom