Recent content by screamindemon

Does this seem like an OK choice ? I like the fact that it is 250psi inlet pressure and will adjust up 150 psi. It's 40 micron but at this point in my system I think that would be OK ? It is rated at 212CFM max flow not sure if that's good enough ...

Yeah, that’s why I’m looking at 3/4 in and out for less obstruction. Probably only regulate it again at the bead blaster and paint booth. Thanks for all your replies,I appreciate everyone’s input.

My compressor shuts off at 150 psi. Was going to regulate it to around 120psi at this regulator then less down stream at my drops if needed. The biggest reason I want to regulate it before the pluming run is for a fail safe. So if the pressure switch would fail on the compressor and the relief...

The cooper and fitting are currently north of $500. I was shocked how expensive it was. But again I need a longer run from my compressor, recommend length to a dryer is 25 to 30 feet. My compressor is rated at 25 cfm @ 90psi. A refrigerated air dryer rated for that cfm will run around $1800. If...

I have another question For a filter/regulator in this position for this purpuse do I want a relieving style or nonrelieving syle regulator ? Thanks for all the input !

Just to further explain my routing as my explaination may have been confusing. Compressor to tank no cooler in between, I like this idea and may impliment this further down the road. Out of the tank trough the wall as my compressor is outside in a compressor shed. To the filter regulator then to...

I have very limited wall space so I chose to run the cooler up and down.

Great info here thanks ! I will also run filters down stream at my drops. I run this at my paint area.

Main reason for a filter before the regular is to keep debris out of the regulator. I will also filter down the line at my drops.

Hey guys looking for a recommendation for a good hopefully budget friendly inline 3/4 inch filter regulator. Want to run this after my tank to regulate pressure to the whole system. After this will be a cooper pipe cooler then Rapid Air lines. My Idea is to regulate it be fore the plumbing to...

Thanks, what do you want to know ? I see you like Pontiacs. I am restoring a 1970 Trans Am for a customer and I have a 1969 GTO I am restoring for myself

I have seen many people doing this and love the idea. I may do this next. My problem is the run from my compressor to my first drop is only 8 feet and the copper tubing will allow for the proper distance for the water to drop out. I actually have an after cooler with a fan that was mounted to an...

New guy here from florida. I restore classic muscle cars for a living. Always looking for ways to improve my shop so this looked like a nice place to be.

Hey guys, New here. I am thinking of building a similar setup. Can you explain what you did on the bottom of the drains to catch the water. Thanks