Recent content by SDavisH

Thanks jtbinvalrico. What did you cut the top and shelves out of? I like the concrete in the base idea.

Thank you, sir. I appreciate the help.

I see. Guess I should have looked more closely. It's a bit more obvious on the 150 DP parts manuals.

Thanks FrankLee. I was looking at the parts diagram and noticed this model, not sure if all model 100 DP are the same, only has one spindle bearing and a spindle sleeve. The one I pulled out has 2 sets of bearings and I don't know about a spindle sleeve. Have you noticed this before? Do you...

Re: Spindle Pulley Assembly FrankLee, I was able to remove the spindle pulley assembly and the bearings are pretty grungy. How can you tell if the bearings need to be replaced or just cleaned? The lower bearing spins very easily, but the top one (right under the inner snap ring) seems to...

jtbinvalrico. I like that stand your 6X48 belt sander is on, do you?. Where did you get that? I need a stand for my Craftsman 150 bench top drill press and that one looks like it would work nicely.

I'll give all this a shot and see where I end up. Thanks again for the suggestions.

Thanks Outlaw. I didn't think about it acting as an etching agent.

Re: Spindle Pulley Assembly Thanks for the suggestions. The electrolysis looked pretty interesting, but I wasn't sure if it was any better than letting it soak in vinegar. I am going to break it all down, clean it, replace the missing/broken parts (if I can) and then put it back together and...

Re: Spindle Pulley Assembly Thanks, Frank. Below are some pics. It's in pieces right now. You'll see in the pictures that a couple of the feed handle ends are bent. Have you ever straightened those out? If so, how did you do it? Also, the base is pretty rusty. Do you usually soak the...

Re: Spindle Pulley Assembly FrankLee, What length hex socket cap screw do you use as a replacement for part #58? I just bought a craftsman model 103.23141 and the original screws appear to be missing.