Recent content by sdgdh1

  1. S

    New to Welding

    Finally added some paint. I've since rounded the corners of the top and cleaned up the edges.
  2. S

    Craftsman Professional Bench Vise

    Quick question. How do you remove the old grease? Heat gun or hair dryer? Chemical?
  3. S

    New to Welding

    No problems at all with the casters. They move around like nothin'. They were a lot cheaper than Tractor Supply. http://www.grizzly.com/products/G8177
  4. S

    New to Welding

    All the steel cost me around $450. Not sure if that's a good rate or not, but I figure I should mention it for someone who might be shopping around. Sent from my iPhone using Tapatalk
  5. S

    New to Welding

    I figure it should be fine until spring and it'll give me a chance to use it a little and see what things I'm missing while it's still easy to add them. I've got a Craftsman Professional 4 1/2" vise (Wilton Tradesman 1750 copy) coming from PA. Not sure if I want to mount it to the top or add...
  6. S

    New to Welding

    I'm not sure what brand, but I got it at Lowes when I picked up the welder. It was the only one they had. I've only got one 220 outlet, so I don't roll it anywhere.
  7. S

    New to Welding

    My wife asked me why I needed a welder and I told her I needed one to build a welding table. She was confused enough not to ask any follow up questions. Here's what I have so far. Still needs paint and the top needs to be attached. I'll have to wait until spring as I'm a little nervous to...
  8. S

    Craftsman Professional Bench Vise

    I found one of these at a Sears in PA. They wouldn't ship it. I had to call an ex girlfriend to pick it up for me. She has it, but I haven't seen pictures to be able to ensure that it's the bullet type. I certainly hope it is.
Top Bottom