Recent content by seabass

Are these shoes really necessary? I am researching this cause I am thinking of epoxing my shop floor, 2000sq ft

I paid 40 for a 40x50 insulated with a concrete covered 14x50 shed on one side, 2 12x12 doors, 1 8x8, and 2 walk throughs... in the Dallas area

Because of money I have decided to use pvc for now. It has a rating of 420 psi so it should do ok for me. I will have 3 reels to work from so there wont be any "pulling" on the pvc directly..... Thanks for all of the opinions..

you can rent some scaffolding with wheels from HD to hang lights, thats what I just finished this week..

thanks, ill see if I can get some pics later this afternoon..

Thanks, I was searching "air lines" my bad... Thanks Ket-tek

I did but maybe I searched the wrong terms, Ill try again..thanks

WHat are your opinions on air lines in a 40 x 50 shop? I have a new 5hp 80 gal Quincy compressor. I was thinking of a hose on a real from the center of the roof that would probably reach anywhere I need to. Should I use pvc or something else? Overyhtinking it onb my part maybe? what are your...

Thanks, Ill see what I can find out

14' walls.... is there a trick to figuring out how many lite fixtures I need?

finishing up a 40X50 and need some lighting ideas... 8'? t-5 or t-8? or is there something better?

Thanks reg

I have the ATTIC FOIL the Spud mentioned and it has been awesome so far...

Planning a 40x50 in the very near future and need some advice. SHould I put epoxy coat covering on it and how much would it cost for 2000sqft? Just general light maininence and a race car....