Recent content by Sean298

Have some damage on the door, frame, and trim of a few doors due to a wheelchair, what is the best way to fix these? I'm fairly competent with sanding, staining, and finishing wood, but have not dealt with wood that is already stained.

You're right, thats what I said earlier in the thread im fairly certain Hold up though, its not all the outlets that blow under heavy load, its only some. But its a whole stretch of them in parallel after the working ones that don't work without blowing.They're on the same breaker, I'll check...

They're plastic boxes and the breaker is a Siemons brand. The circuit apparently had a shared ground between some other new construction and the garage, the inspector made us put an afci, don't remember why, but this older wiring is terrible for those breakers and my lesser knowledge of them...

The outlets are not gfci, its probably code to have them be gfci, but not necessary in my mind. I believe the breaker is a 15a arc fault breaker with multiple other things on it, 14 guage wiring if I recall, nothing special. Not sure if they are very high draw items but I think that's one...

I've been working in my grandpas garage a lot with some high load tools at times, power comes down into the switch box and goes out to the outlets, one works flawlessly but all the others down the line blow the breaker with not all that much load. Pic not so relevant, the one with the chargers...

I looked at getting a little 26" but it was like 350ish for that or 600ish for a bigger one, seemed like I'd be wasting money if I bought a small box hen I could get a bigger one for not much more. And its mostly full right now, it works very well. Jakes right about that, I love working on my...

I picked up my craftsman 41" box for a lowly $340, register screw up, discounted me the craftsman club twice. Its a very nice box, holds everything I need as of now. Its pretty damn good for a 19 year old lube and tire guy.. All harbor freight and craftsman, no complaints. My entire tool...

For quite a while I used one of their red tables with black legs at the shop I work at. I put my tools on it and use it as a workbench, it held up really well. I could sit right in the middle of it with all of my tools on it and I weigh 135lbs. Only cost me $40.