Recent content by segermech

I recently purchased an F80 ratchet and I must say I am not a fan. I find there are too many teeth now...I cant imagine using it for 1/1000 on a turn at a time anyway plus it seems that the head is larger than the F936. I assume the larger size is to house the new finer mechanism. Also the...

11'4 is as high as I can go (it's an attached garage) and will mess with the elevation so that is set. And the issue is that where the door comes up will also need to be as close to the ceiling as possible so the door can be opened when a car is on the lift. If lights are placed in that area it...

On the hunt for lighting in my garage (not built yet). It's a 3 car ~ 36ft wide x 25ft deep. Ceiling height is ~11'4" (just tall enough for baseplate type 2 post lift. Due to the somewhat low ceilings and the fact that lights need to be installed directly over the lift bay I need recessed...

I have a new big max heater 75k. And most of the time it works no problem... Vent blower turns on, burner fires, Then the fan kicks on. Weird but sometimes the blower turns on then the fan kicks on for like 2 minutes before the gas turns on. Anybody have an explanation for this??? Thanks

Yup I think I'll get a smaller unit to put on the bench

Here is a photo of my new vise. Still need to bolt to floor.

Hi everyone, Regarding the vent slope for a hot dawg/ big maxx forced air heater... Manual states upslope 1/4" per foot. This means condensate will run toward the heater, seems backwards to me. Can someone explain this upslope requirment. Seems like a power vent would not care about the...