Recent content by sharpie_101

I dont think so, but the first coat showed areas were it cured differently. It had a different sheen on certain sections if that makes sense. The primer was a polyurea and had a part A and B as well. We had quite a bit of primer left and therefore decided to do a second coat. After the second...

Replying to Shea as I forgot to quote: No, we did not do that. I never even thought of doing that. Part B was extremely clear and thin, almost alcohol like.

I cannot for sure say its not due to outgassing as I do not know what that looks like. I thought if it was outgassing when I sanded I would have found air, am I correct? This roughness is solid and it appeared all over the place but in certain areas it is more pronounced. We did mix it for 3...

I am in the middle of a coating job and wonder if you could chime in with what could have gone wrong that caused this to happen. This is the epoxy after two coats of primer on a freshly and thoroughly cleaned floor. The weather was in the 70s and it was dry. Before starting, floor ground...

Good morning, After countless hours reading the board I believe I have more questions than answers. I have a 675 sqft garage that I want to epoxy with a good durable epoxy. I have used Epoxy-Coat’s product before in my current garage and even though it has been ok I am looking for a better...

This is exactly what I want. I want to get home from work at 5:30 and be able to turn it on and get to work on my car in an hour or so. If it can be controlled remotely, like the Mr Cool says it is, I can even turn it on from work and have it ready by the time I get home. Once I am done...

The side with the double garage door has 16" of blown insulation on top, plus most of it has the second story up there. The right side, or 1/3 has zero insulation on the roof. I think I made up my mind and will order the 24k BTU. I know most of you will disagree with my choice, but I am not...

Thanks for the input! What do you mean by the inverter? Are you referring to the variable speed feature?

Looking at cooling my attached 3 car garage. 650 sq ft, cinder block walls, insulated garage doors. The side walls are exterior walls and the back wall is 1/3 exterior (block), 2/3 shared with house. Some insulation on the roof as the second story somewhat overlaps it. Location is south...

Any updates on this thread? Looking to build an attached 40x26 CBS in Boynton Beach as well but I have no idea where to start. Sent you a PM Tom.