Recent content by shlbygt

Termidor SC, it's what exterminators use.

The BL-5000SLX fits a 2003 Miata with 205/50-15 tires, barely. The QuickJack needs to be placed with the rear of the QJ up against the rear tire. In the full upright position the front of the QuickJack is within a half an inch or so from the front tire. Moving the steering with the tire on is...

You are missing the feet.

Back from the dead. The local Direct Lift dealer was at the GoodGuys show a few weeks ago and one of his helpers that day was a guy who installs lifts and other equipment for dealerships. I explained to him my constraints and what I was looking to do. After a few minutes of noodling on it, he...

Can't change the tracks as there is a solid wood beam the hangs roughly 18" below the ceiling, which supports the second floor. The beam is about six feet from the garage door opening. As a result is has low headroom tracks installed. It originally had a one piece wooden garage door that is...

I am looking at purchasing a lift for parts storage above a car as my ceiling height (100inches) will not allow me to stack cars. I have approximately 75 inches of clear height with the garage door open. My first thought was to cut the slab for each column and lower the slab 6 to 8 inches for...

Was it a 110 volt or the 12 volt model?

Then again, you could have read the specs on the unit and measured the cars before placing an order and not been disappointed.

http://www.sonaxusa.com/blog/sonax-wheel-cleaner-full-effect-3

Guess there just wasn't enough information here? http://www.garagejournal.com/forum/showthread.php?t=245515&highlight=fire

Did you periodically inspect them or just purchase and forget?

I did not think these were available until August. Where did you get it?

That tools works like a charm and only runs about $18 shipped in the US.

I've had a couple of them in various sizes for about five years or so. They work very well in a number of situations where a regular socket extension puts the ratchet in a knuckle busting position. I like to use them to remove header bolts from cylinder heads. On my SVT Focus I'm able to rotate...