Recent content by ShopNotShed

Yeah I think you're right about the tanks too. I wanted them to drop a 250-300 gallon tank because I knew I'd go through too much for a 100 gallon tank. Also there are not many propane providers where I am. Maybe 3. OH well, it's done and it works. Let's just hope the trench they dug up settles...

Apparently they have too many people around here with "small" shop/garage tanks that they have to fill 5+ times a year versus the house tank once a year. I even asked if they'd just drop a 500 then and no luck.

Couple months late here, but I'm in Western Wisconsin and maybe jumped the gun on a 125KBTU unit from Big Maxx. I have a 30x40 with 10ft ceilings and R15 in the walls and idk what's in the ceiling but probably more. 2 9x10 OHD's, a service door that is terrible and has at least 3 inch gap on the...

How do you get these figures? Thanks for the info, super useful!

Thank you!!

Would you be mounting these into wood? Sheeting or trusses/rafters? Why not just mount the brackets direct to the wood? I've seen people on here and YT do that. You get the 1in required clearance on the top from the bracket to the heater itself.

Installing the venting for my 125KBTU unit and just made the decision to switch to vertical instead of horizontal. With vertical am I able to use B-Vent instead of Category III?