Recent content by Shrek

Oh I totally picked up on my mistake of calling it 110.

You guys got me on the 110v welder. Well done. Hope it provided a few laughs. The welder is a Millermatic 211 Auto-set.

Thanks everyone!

Excuse my ignorance, but what does size the breaker to the wire mean?

Greetings Lads and Lasses, I am seeking your grand wisdom once again on a wiring setup for my workshop. I have a 6 breaker sub panel 1 - 4 3' LED light strips 2 - 1 outlet dedicated to a window AC unit. 3 - 5 outlets 4 - 4 outlets at my bench 5 - 1 outlet dedicate to a 110v Miller MIG welder...

Is there a minimum height from the floor?

Greetings all, I have a 20' × 10' workshop that I am going to start wiring soon. My first question though is if this location is suitable per TN code to put the panel to the left of this window. Counting from the window, the framing of the window being stud #1, I would put the panel between the...

After taking some measurements in the garage there is not the proper clearance for the sub panel. The corner that is between the HVAC and the chest freezer is large enough for the water heater. Are there codes that would prevent me from moving the electric water heater into that space? This...

Jack, Do you happen to have a build on the over head cabinets? I like the look of them and thing something similar would work great in my space. Thanks, Glenn

Does that have to do with if the house was built after 2008? (1970's home)

I was going off of where it already was located. Might be a code time to move it though...

Sweet! Thanks a lot. Also you were correct on the 220 between the garage doors being for the welder. I think I'll take your advice on the extra two outlets on the other wall.

Also found a couple of poor cell phone shots of the garage over on my normal hang out. http://naxja.org/forum/showpost.php?p=244384339&postcount=781 Garage is 470 sqft, 23ft by 19ft+

Wooohooo. After lurking for sometime and not having in thing put together enough to get the info I needed, I finally get to post my first thread on GJ. After drooling over many of the build threads on here I know I'm seeking out the right crowd to ask for help. I'm planning on re-wiring my...