Recent content by shuie

I need some kind of a plan to move a Bendpak LR60 from a friends garage. The challenge is going to be getting it out of the garage without damaging the epoxy coated floor. Im not sure if it is the portable version with the integrated casters, but either way, we won't be able to just drag it out...

Awesome. Thanks again. Good info.

That is my biggest concern with this style lift. The height will be plenty for me. You have a 993, right? Is there enough room under the car to get an engine cart in there without it falling into the pit?

awesome. thanks again. coreseller, did you dig and pour any concrete under the edge of the recess you cut in the original slab for support? Or, is that just not needed. I see the piers and the rebar in the pics, but is there anything tying the old slab to the new recessed area?

Thanks for the info. Do you have any issues straddling the pit when you park over the lift? Do you think you could have made the pit any narrower?

Awesome. Thanks. That may seal the deal for me. Northern Tool was an additional $90 for a lift gate and it was going to cost an additional $190 for shipping and a lift gate if I went with the Atlas. I found a local guy who is upgrading to a two post and wants to get rid of his current setup. I...

Nope, never got any solid dimensions. All of the portable midrise scissor lifts I have looked at vary on the spec sheets by 1-2" in length and width. I'm going to make a decision and buy one within the next week. I'll use it with the ramps until I find out exactly where I want it in the garage...

Thanks for the help. I've also been looking at the low rise pit style P-6FB. I need to figure out if it has enough lift to do engine drops & installs in my cars. The online specs say 29" with the pads, which is probably enough. SP-7X is 2x the cost and I don't have the ceiling clearance for it.

Does anyone have the pit dimensions to flush mount a Bendpak MD-6XP? I called Bendpak and the tech guy would not provide any dimensions for a pit because they don't recommend installing it that way. I understand that the lift can creep, but I have seen many similar 6000lb mid rise scissor...