Recent content by silber

Apparently GJ doesn't like Imgur so I had to host elsewhere. Hopefully they load now ... Unfortunately, no left over cans. I tried to reach out to the installer but his phone was disconnected and looks like he may no longer live here. There is an area under one of my cabinets where I could...

I had my floor professionally done by Color Surface here in Louisville KY about seven years ago. Over the years, I've had several spots lift from hot tires. Unfortunately it looks as though the company has dissolved so I am trying to figure out what I can do to repair these spots. Are there...

I have six four bulb fixtures in my two stall (20x24) and I've been thinking about adding another fixture. You can never have enough.

I just finished my lighting project a few weeks ago so may be able to give some input. I have a 20x24 2-stall with a 16ft door. I chose to use six 4ft 4-bulb t8 fixtures from Home Depot. I have three in parallel and the fourth perpendicular similar to how yours are in the picture on one...

I bought 6 of them over Black Friday. Not a bad deal IMO and they look great. The only thing I wish is that they were a tad deeper.

To be honest I am not sure -- I had these guys do the floor: Color Surface I tried the Purple Power but it didn't do much if anything at all. Here is a shot of the stain left over. You can barely make out the yellow color running down the middle of the shot but it is much more noticeable in...

I tried some basic household cleaners -- poured on, agitated a bit, let it sit, agitated again, rinsed but didn't do much. I picked up some Purple Power tonight to try tomorrow. I also tried Simple Green (don't know if this is one of the best or not). I'll try the PP tomorrow. The stain is a...

I am trying to lift an approximately week old brake fluid stain on my epoxy garage floor but am having some difficulties getting it up. What is the preferred method of lifting old stains such as this off the epoxy? All of my other spills have been painless in cleanup but this has proven a bit...