Recent content by SilverJimmy

As a bonus that will be the greenest part of your lawn!🤣

Could you just run the drain outside your shop and into a dry well? It’s just soapy water and a bit of grime. I was told I could do something similar here in Coconino County, just run my sink into a piece of leach pipe along the side of my shop.

Wait till you see my new fence! I didn’t even break a sweat! Photos tomorrow cuz it did happen! Your fence is looking great, I wish I had the same finish skills.

Sounds like you need a simple solution from Pulp Fiction…. A couple hard hitting dudes from the SouthSide with a pair of pliers and a torch!!!

Last Friday a fence contractor started phase 2 of my outside storage yard by concreting all the 2” and 4” steel posts for the privacy fence. Then on Tuesday morning he came over and started welding all the horizontal steel onto the verticals. I’ve been in Flagstaff since Tuesday for a eye Dr...

Or made into a Ward of the State doing 10 to 20!

I haven’t even mastered my Drill Dr and now I need to replace it?! Thanks…. I think!

Did you try using WD40 as a cutting lube with that blade? If you do it’ll cut like a hot knife thru butter! And the finish will be perfect! Just sayin!

Go to Dr tomorrow morning. Gas in eye is mostly gone. Driving up yesterday from Prescott (5150’ elevation) to Flagstaff (7000’ elevation) was a non event. Still stopped at the same places as trip last month but this time zero discomfort. Last trip a month ago it hurt so bad I thought I was going...

Birfields? Yup, learn something every time I’m on your thread! Thanks Mike!

I have no knowledge of the RCV axles and how well they last but I wonder if in an application with locking hubs with not as much rotational time would they still be a good choice? My 1992 Toyota Land Cruiser has almost 300k on it with the original OEM Burfield joints. I had them repacked and...

Most people when they hear a rattle just turn up the stereo, I’m just happy I can still hear a rattle!

Such a considerate guy to leave him room for paint….

Oh Boy, tractor ****!!! I’ll have to give my MF a bath before I shoot the money shot!

That doesn’t look like a PC Pounder!