Recent content by SixStringMadness

I'm looking for a coupon for the 2 Ton Shop Crane, anybody have one of those?

Good info, thanks for the help!

At this point I just got tired of guessing, and found a guy to come out. He added 3 pounds of R22 for $150.00. I'm a little concerned he didn't look for a leak, even when I questioned him about leaks, but for now the temps are dropping inside, I'm taping the air leaks on the coil box, and...

I'm not talking about the gas pipe, I'm talking about between sheet metal. The exhaust fan housing, and removing it to get to the underside of the coils to clean them. As far as the motor goes, the red wire says high speed, and it terminates on the cool terminal of the control board, just like...

I would like to give you an answer of such and such psi or flow rate, but my answer is completely subjective. It's better than it was. Upon removal of the coils inspection panel, with the unit running, the air coming out is quite chilly. Enough to make me want to go put a shirt on.... But my...

I appreciate your input, I do, but of the HVAC things I could screw up, the electrical portion is not one of them. It will **** the air filter in both returns right out of you fingers. I did not wire the fan backwards, nor reverse any of the speeds. We have not used the AC all that much this...

Okay, I've allowed the unit to run for about an hour and I have now noticed the large copper line is freezing where not covered with insulation. It was not doing this with the old blower motor yesterday. I looked inside the condenser (outside) and the compressor was starting to freeze also. I...

I have a Carrier 8000 weather maker, 58WAV091-14114 I replaced the blower motor and capacitor, due to very low air flow. Now the unit blows, but the difference in air inlet and outlet temps is 10 degrees or less depending on which vent I check, and is having a difficult time bringing the temp...

Ah, 10-4. Looking good!!

Forgive me if I missed it, but what are your plans for this? Auto shop of some sort I guess....?

Wow, nice looking shop, just up the road from me. :thumbup:

I bought the 13 drawer when they were clearing out the matte finish, not realizing that was the reason, and didn't grab a top box until there were no more matching matte finish. So I have a matte finish bottom, and gloss top. Oh well, they're my first tool chests, and much better quality than...

this is Cooper, my Bluetick Coonhound

Re: what did you do in your garage today? I don't have any of the pictures of the during, they're on a friends camera and he'll be emailing them to me sometime this week. I'll get those in later..... I replaced the front leafs with a 2.5" taller leafs, shocks, steering stabilizers, and F350...

+1 on the cart, and yes to the don't tighten until fully assembled :thumbup: +1 on the 3 ton jack :thumbup: