Slednut's latest activity

I’ve been driving my Fairstang so much that I haven’t really worked on it to fix the last few things. I did install Mustang tail lights...

Clamp it down on some big V blocks.

Below is the weld sequence I use to maintain alignment on pipe and tube. Tack weld at 12 o'clock, then 6 o'clock, then 3 o'clock, then 9...

Thanks, that’s exactly what I needed.

Sorry, if you look close at the picture. You’ll see the DOM tubing has been turned down (shiny part) to fit inside the original...

My SIL turned this piece of DOM tubing down so I can make this drive shaft longer. Once I press each end on so it’s at the correct...

Looks great, I weld a piece of rod stock to bend the sheet metal around.

The freight company dropped mine off at work. I used the fork lift to put it in the back of my truck . Tied it down for the ride home...

Lainey my 8 month old shetland sheep dog is always by my side.

C channel framed doors.

It’s a 1970 Mercury Cyclone.

I have a 26 x 56 attached shop/garage. In the past ten years besides many small projects, I built these two cars and painted them in it.

That fiber seems to have standard "LC" connectors which are 12.6mm, about 1/2". I'd run 1" conduit just to be sure. Conduit and fiber...

Go with the fiber, the lightning strikes are a good enough reason. The pre-terminated cables have a pulling eye already attached that...