Recent content by Slimjim6100

I started doing them. They're not bad but definitely need someone to help. The faced would be a lot easier but they were gonna cost me about 1000 bucks extra so I just went with the unfaced

Accidently posted it twice when I posted it the first time. My phone said it didn't post and couldn't figure out how to delete it. I posted that comment so others knew that they wouldn't stay with just friction since I couldn't find any info on it and what I did find said they would stay

They're unfaced. Wasn't sure if I should use cap nails since it'll compress the insulation a bit where they're at but that's probably what I'll have to do

I got 8' wide rolls, 55' long to fit between the posts on my pole building. I'm going to put interior girts across and put metal on. Do I need anything to secure them or Will the fiberglass stay between the posts on its own. Thanks

They would go between the 6x6 posts. They're 8 ft on center, it's not studded up, that's why I'd prefer to use the foam board as long as it wouldn't be an issue. I plan to add 2x4 girts across the posts on the inside and put metal on the walls

I'm getting ready to insulated the walls on my new pole building and not sure what to use. It's 32x40x13. Had it house wrapped when it was built to. I can get enough 3 inch poly iso for 1600 or 4 inch for 1800. If I use fiberglass it would cost me a little over 3 grand for r19 with all the...

I built a pole building last fall, it's 32x40x13, 2 insulated 12x12 doors with r13. When it was built they put a metal ceiling in with r19 bats. I'll probably end up blowing more insulation up there eventually, but I want to get the walls done first. I can get seconds poly iso foam board for a...