Recent content by SMKN LS1

and the motor/reservoir extends off one tower by an additional 8”-9” on the 174” side. It’s obviously higher than the base plate...

174” x 100-3/8” on mine. Built in 2012.

I’ll see if I can dig up any photos with the car beneath it. The ceiling is too low to stack two ordinary cars, but I may have put something else up on the lift for storage. Since installing, I’ve added the RJ-45, dedicated air and power lines, and modified the entry ramps to clear my...

The Wayne Dalton units are still available on auction sites if one searches hard enough. But, I also prefer the Liftmaster 8500.

9 feet

ovilla - thanks for the recommendations! I think a jacking setup will be needed to take full advantage of having the lift. How do you swap the jacking tray with the RJ-45? Just pick it up off the lift? Fully agree on the light fixture. I have to rework all the ceiling outlets and am saving...

Hi everyone, New guy here! So, I wanted to start a post about my recent experience with adding a BendPak lift to my garage. Hope it will help add to the great depth of coverage here for those interested in buying a lift. Searching through this forum definitely helped me in deciding what...

Hey Bandit, I just went through all of the same decisions you're thinking about last month. Which lift?, what will fit my garage?, what size car will fit on it?, etc. I looked at all the same brands you are, but kept coming back to BendPak. They seemed to be most interested in the customer and...