Recent content by snappy88

I'm digging up an old thread here, but was wondering if anyone has any info on the Chrysler Snap on ratcheting screwdrivers. Thanks!!

Hi- does anyone have any recommendations on replacement blades for Snap on screwdrivers? I know Snap On sells them directly for tons of $$ and they seem to be reluctant to send out replacement blades because of liability. I don't want to loose my hard handles so I need to find a replacement...

Hi, I am wondering if anyone has converted a Snap On 1/4 Ratchet model TFY72 to a TRF72? I was going to purchase a TRF rebuild kit and try it but wasn't sure of the hole on the back of the HI-LOK ratchet matches the size of the hold for the quick release? I know this sounds crazy but I don't...

I am looking for some bits for the older Snap-On hard handle ratcheting screwdriver, model SSDMRM. These bits came in flat and phillips and were 5" in length. Does anyone know of any part numbers that I can use to reference these bits? Of course if you have any, please pm me! As a reference...

No lock on the flex handle.

Hi- Has anyone seen a Snap-On 3/8 Offset Flex Ratchet like this before? Obviously mine is broken and the handle long lost (which is where the model is usually stamped). I am hoping someone knows off hand what model this was. I have seen F series ratchets that are flex (F712, F732) but not flex...

Its miniature... smaller than the regular full size ratcheting screwdriver. They did offer to replace it with the full size unit but its not the same. Hoping to just repair this unit.

I have a Snap-On SGRMINI Mini Ratcheting Screwdriver that no longer holds the bits in nice and snug. I reached out to Snap-On and they do not offer a rebuild kit for this driver. Has anyone had experience with rebuilding these screwdrivers or at least replacing the part the holds the bits in...