Snip's's latest activity

Good to know everything went well and to have you back in the game

DP#152 - Part 1, Acquisition, Assessment, Disassembly Overview The last week was relatively quiet. When I saw this 150 on FB a few days...

This is what I copied from Eric O... I need to add a few pieces of heat shrink tubing on mine to the alligator jaws to protect the wire...

Nice job! I've been wanting one of these. Nice magnet swivels and base. Some ideas for your Rev 2 version. I think @zmotorsports...

Not much in the garage today... I was watching Eric O on S M Auto do some wiring repair today and noticed he was using what looked like...

We burned the midnight oil this weekend getting things moving on the trailer. Started by mounting the newly fabricated roll pan in...

Okay, I didn't need this one, but I couldn't resist. Delta Triple Duty grinders rarely pop up for sale in my area, so when I saw this...

Just tell your wife you need to go to the grocery store for a gallon of milk...

OK... Pulled vs. Rolled... You'll never ever see it being used with rolled tubing... Different method, different tooling...

Here is an example how an internal mandrel bender works, in this case for a round tube profile, but square is similar... The mandrel is...

You would have much better success going with a fabricator that uses bending tooling / equipment that uses internal mandrels (sometimes...

Years ago (before 2015) I used to have an older riding mower model MTD YardMachine (purchased from MonkeyWards (a.k.a. Montgomery...

Part deux today... Cleanup on the JD mower deck... Lots of grass buildup (I hate it when I have to mow the grass when it's wet)...

Today, in front of the garage, my JD 330 Garden Tractor got... A new transmission filter and 5 quarts of Type F transmission fluid...