Recent content by Sovereign-1

Never mind, got it now

I purchased an Atlas pro8000 and am also done with the installation. I went to inspect the cables before lifting it and saw one of the cables was off the pulley. The fully is so close to the end of the runway that the cable will not slide between the pulley and the runway. The cable end will...

Welcome Steve, I am in Wichita.

While I am still a year out from buying one I too am struggling on what type to get. I am leaning towards a 4-post since storage will be the main function. Ideally I would get a 2 post with wheel engaging lift arms (Mohawk setup) but the cost of the lift plus the wheel arms is cost prohibitive...

Looks awesome, nicely done. Tiling my garage floor is on my to-do list. It will take a while before I get there though.

Something like this? https://www.amazon.com/dp/B06X8Z255M/?tag=atomicindus08-20

Profusion PH-960N

The manual stated the use of a 35 amp breaker, so that is why I assume the same capacity for the thermostat.

Mine is a profusion 6000 watt. I didn't see any provisions for a separate thermostat control.

Hello GJ, I have a 240v electric heater on a 35 amp circuit that I use to heat my garage while I am in it. However to make sure things don't freeze in there when the temperatures really go down I would like to put it on a thermostat that would keep it at or above 35 degrees. All of the...

I just put in 46 bags of blow in cellulose in my attic. I put 7" over the attic and then topped up the rest house with a couple more inches since I had the machine. 7" gives me about R20 but I only use my heater a few hours a week and I too use my attic for storage so I upended studs along my...

Can always use more tools.

Depends on the top coat you use. Here is a thread that may be of interest to you: http://www.garagejournal.com/forum/showthread.php?t=221119

Ah, I see now. Thanks.

You and everyone is thinking its a 2-2-2-4 AL SER wire but you have 2 0... did you mean 2/0. If this is 2 ought cable then all is fine. Maybe take a picture of the jacket? I am just an amateur but I just want to be sure we all know what the wire truly is.