Recent content by Sp180

Fantastic ideas! I am loving how you put the tool chest in the work bench. new not to self on that one. Also the socket idea is very nice.

The shelving was an idea to keep my floor space since I was only putting up a 30x36.

I am in Nowthen, Minnesota. The walls are 10' high.

More pictures!

This project was a year in the making. December the pole barn was built. September the floor was put in by myself and family and October I ran cable and electricity (never done electricity before) with only 2 trips by the inspector. Enjoy!

Just finished cementing the pole barn. Now comes the electric, but I had sticker shock at the wire. This is my plan, will this work? the panal at the house is going to have a 100A breaker sending 220 for 240 feet along a 2-2-2-4 Alum wire under ground. This will enter the barn into a 100A...

Can I not pull through each 10 foot section at a time? Then glue them together?

Nowthen Mn

If I am pulling 2, 2, 2, 4 Aluminum feeder, what size conduit do I need for 240 feet and one 90 degree turn?

Metal and vertical.

Working on putting in my lighting. On the outside I want a light on the peak of both gables. The problem I have is the siding ribs are right in the middle. What do I do? How do we negotiate this with out changing my light positions? (small thing, but will drive me crazy) Thanks, Mark

not sure what kind as this will be next years purchase.

Yes I will have a compressor and a welder. No AC or heat. One man shop.

My first post! Been a recent stalker here but need a more specific answers then I am reading. here goes. 1. Running 240 from house panel to pole barn panel. 100 A for 250'. What type of wire do I need to run? A brand would be nice and type. 2. Can I drill holes to pass wires through my 6x6...