Recent content by Sparkynutz

Turned out pretty good. Will put some decorative lights in the rocks.

Unfortunately it faces West. Still better than nothing tho.

Little update. Patio and lean to on side of garage. Definitely came a long way that would not have been possible without lifting garage. Had issues of dirt washing out during last rain where green drain pipe is laying. I'll probably surround the area with river rock similar to the window well...

Little update. Driveway is done.

I actually flipped the breaker feeding attic lights and garage door opener off for a few weeks. Hopefully it won't happen again that I'll need to. There was no concrete, just bare posts in dirt 4ft down. The lattice looking face boards last owner installed against ground were rotting too. They...

Challenging for sure. Place I worked at 18+ years closed its doors. I jumped at the first good paying job I could find that ended up being managed by very unethical people. I knew it wouldn't last much longer. I put in my notice and took all my vacation to take a $8 hr pay cut to find out they...

More pics of grading.

Little update. Been a while with 3 job changes and finally some free time. Hoping to get around this winter to putting out a start to finish video on the raise and completion of it all. Last winter my wife accidentally hit the wrong garage door button and didn't check. The door was open for 18+...

You're overthinking things. Throw down some gravel compacting every few inches till its level then if you want, put down a solid concrete block at each corner then fill rest with gravel after dropping shed onto final blocks. That's what I did. If shed was rigid enough to move on a trailer its...

https://www.harborfreight.com/3-ton-long-reach-low-profile-professional-floor-jack-with-rapid-pump-orange-64241.html This is what I have. Hard to believe 3-1/4" don't fit. Sent from my SM-G960U using Tapatalk

try the long reach low profile jack. best jack for the money I've seen. I have two so I can jack up both sides without moving them. Sent from my SM-G960U using Tapatalk

A picture from this in another thread brought me here. I've been looking for ideas to build something very similar and yours is the closest I've seen to the idea in my head. Few questions- What are the hinges used on folding table? (I bought some folding locking hinges from Amazon but after...

link doesnt work. any updates? I'm hoping to build something closer to your design very shortly. Sent from my SM-G960U using Tapatalk

Re: 10x22 Project - renamed ‘ATTREZZI VELOCE’ Nice thread and setup! Couple questions- What are you using for power supply? Info on that upswing door or hinges on left cabinet? From menards? I'm looking to put 10" cabinets above regular cabinets and would love that kind of door on them instead...