Recent content by Spridle

Why not run DOT airline with push to connect fittings. It'll stop a semi, so it'll work for me. look at Suicidedoors.com for fitting and line pricing. Copper is prone to stress fractures as it work hardens through the vibrations. If you're useing it, I strongly suggest some type of flex between...

Ive used a bunch of their products in the past. The 2 that I liked best was their sprayable seamsealer, and the thick black nasty undercoat, its thick as tar and waterbased.

I just put up a 28x32x10 with scissor truss'. Its about 13' in the center on a 12-4 roof

I must be a redneck. I used some heaterhose and a ziptie.

Does anyone know if you can bury CSST?

The CSST isn't used very much in the Chicagoland area. I've used it some, mostly for temporary hook-up. I liked it. It was a lot nicer than being covered in oil.:)

OK, your putting black pipe outside of the building but wanted to run something else inside? Are you going to bury the pipe outside? If so I would strogly suggest plastic for underground. Get some normac fittings. and dig your *** of. Dont forget to run a wire along with the tube though. Itll be...

Hmm. You could look for a pump in a can setup as well, you would need to check the capacity on them. I forget the actual names from different manufacturers. I know Zoeller makes one. They also require a vent pipe. Also. Unless you had some seriously bored plumbers there. Thats black pipe...

heres mine