Recent content by sstevesc

Sent from my STV100-3 using Tapatalk

Almost have the vapour barrier complete on the ceiling. What a pain! Had to take a break to prep the car for motorama/spring fever in Toronto. Sent from my STV100-3 using Tapatalk

Finished up the wall insulation and started to put up the vapour barrier. Got a screaming good deal on two lift Master 8500 door openers. 580 Canadian for both with a keypad. Got one of them installed today. Sent from my STV100-3 using Tapatalk

Yes they are just shy of 13' ceiling. Sent from my STV100-3 using Tapatalk

I finished up the utility room that will house the compressor and water heater Sent from my SM-T560NU using Tapatalk

Was able to get the final building inspection completed last week, and a good chunk of the insulation is now complete on the walls.. Just need to run one water line before I can finish the walls.. I also got started on the attic access, bout 60x22

Led light at night

Got some outdoor lights installed today

Starting to get back on track with work in the shop now that Christmas and Boxing day are over with.. I was able to get all the in-wall air line drops installed. There is a main 3/4" PEX line running around the shop and then up into the ceiling. 3 drops on each 40' wall, and 2 drops on the...

Well I got the Electrical Safety Authority to approve the electrical today, and they gave me the full approval instead of just a rough in inpsection so I was able to turn on the lights.. The lights are 5000K Hyperikon LED no ballast lights. I was planning for 3 lights per fixture but I think I...

Got my all clear on the Electrical inspection today! Now we can run some water and air lines and get the building insulated!

Thanks, read the full build here: http://sites.google.com/site/gobaltss

The Hydronic in floor heating system needs to have insulation panels installed under the concrete slab. For this I used Insta Insulation Insta-panels. Then you need to have Pex tubing stapled to the panels at 1ft spacing covering the entire floor. My friend is a HVAC/Plumber tech so he is...

Here's a few pics of the toys going in the shop when its done : 2007 Chevy Gobalt SS 6.0L LS2 Rear wheel drive converion (AKA V8 Go Cart) 1969 Ford Fairlane 302 V8

I figure I will get a nice tan from the lights. I've got them on three seperate circuits though, so I should be able to control skin colour :)