Recent content by Stephen00GT

Re: What did you do to your garage today? 2 rods and 2 pistons were crushed up into small pieces. 3 rods were bent like the picture. Skirts were broken off of all but one piston. Dime size hole in the block. Bent 3 valves and broke the guides. Ripped the baffle loose in the oilpan and knocked a...

Re: What did you do to your garage today? Tore apart the car and pulled the engine. Then tore down the engine to see what the damage was.

There is a slight uphill slope leading into my garage. It is enough of a slope that i can't push a car into the garage. What would be the best way to put an anchor in the floor that i could attach an electric winch to in order to pull the car?

I roll mine under the toolbox

I was just going to ask this same question. I have a 24x40 that has about a 1/4" bow in it

Does anyone own or know anything about this welder? http://www.northerntool.com/shop/tools/product_200332691_200332691

I did something similar to that in my garage except my air compressor is on the top and the mower rolls underneath of it.

I'm also curious about this.

I bought the $4.99 one and it leaked when brand new. I tossed it. Definite fail from my experience.

Was this box always the same size? Were all the boxes with the door on the bottom the same size? Where will the model number be in the drawer? I looked but didn't see anything. I will look again when i get home from work.

I've had this box for about 15 years. I was looking for another one but wanted to make sure that the one I found on craigslist exactly matched the one I have. I didn't know if they were all physically the same size and layout.

Can anyone tell me where to find the model number on this Craftsman tool box? Is there only one model like this or are there different versions that are heavier, different slides, etc, but all look the same at first glance?

Does anyone know if the price changed in all Lowe's stores?

I pm'd this same question to Christine and was told that store #456 in Bristol is the only one in VA.

Hi everyone. I have been reading the forum for a while but just registered. I recently started working on my 2 car attached garage. My first project at our new house was to finish the basement and now that I have done that it is time for the garage to get some attention.