Recent content by StewPidass0

You know how when something doesn't work like it should you start ruling out what it can't be? It can't be the wiring, it can't be this, it can't be that. Well, I had tested amperage on one leg only & didn't bother to test the other leg...turns out I had 120v going to the leg that I was...

I didn't measure voltage while under load, I'll go do that from empty to when it starts resetting. I just pulled off the belt & motor pulls 1.45-1.53a...let it run for a while to see if that would build any heat/etc but never went higher. I can spin the flywheel on the pump by hand there's no...

Been lurking on the boards for a long time & finally registered to see if I could get some ideas on this issue. Moved about 2 years ago & thought I didn't need my 60gal Sanborn single-stage air compressor...got a great offer on it & decided to sell so I didn't have to move it to the new...