Recent content by Streetbu

I'm betting its overheating and the snap switch is tripping killing the flame.

Pergo laminate flooring in Heathered Oak is on sale in Auburn NY and a few other stores in our area. I was able to pick up 36 boxes and also take my military discount on top :) I walked out the door for $1.69/sqft after tax...

Hardwood is cold. We're currently planning to demo our existing house and rebuild this year. Carpet for the bedrooms, livving room, and hallways, hardwood for the kitchen & dining room. Tile for the bathrooms is what we are doing.

https://www.homedepot.com/p/Dyna-Glo-30-000-BTU-Infrared-Vent-Free-LP-Wall-Heater-IR30PMDG-1/206556627?cm_mmc=Shopping%7CG%7CBase%7CD28I%7C28-22_BBQ+GRILL%7CNA%7CPLA%7CBrands%7CFixed|71700000032321202|58700004410186037|92700037079252496&gclsrc=aw.ds&&gclid=Cj0KCQiAlIXfBRCpARIsAKvManxadbevR_5tE4Hf...

If you're not good at using not just any MIG, but that one in particular, don't start by trying it out on those headers. 16ga sheet metal that they are probably made out of is very easy to blow thru with a cheap welder and no experience.. Can it be done? Of course, but attempt that as your first...

We heat a construction trailer that is out hunting camp with the same heater and a 20lb tank. Start it Friday evening, runs all night. Turn it off all day Saturday until we get back in about 6pm. Runs all night til Sunday Morning. Depending on temp we might run out in the early morning, other...

Wow, not sure where you guys buy your water heaters but you're getting screwed. I bought a Bosch on demand propane water heater. Smaller one, we only have one bathroom. Between plumbing fittings, moving the propane line, exhaust pipe, and the heater I had 1k into it total. I consider my labor...

One of the many reasons they say not to run electronics on a cheap generator, and only on an inverter generator.

My buddy bought a mounter and a balancer from National Auto Tool. Both were Chinese. He had a smaller two lift garage but did a decent amount of daily business. That was 12 years ago and they are still working...

Easy, ship it to your work, cheaper for a business address, then back a regular pickup truck up to the tractor trailer and slide it into the back of the pickup....

Here's a link for Sunoco. I was surprised to see the 100 octane had ethanol in it.... https://www.sunocoracefuels.com/fuels

Thanks Tommy, get crackin on Madge, I could use some company!

Drove my project car out of the garage for the first time since replacing the frame, and a just about every other part on it.

I plumbed my 24x34 shop with 3/4" galvanized. It's funny how people mention how much galvanized will that with water, then in the next breath say how you have to install some massive contraption to remove the water from just before the main line. Wouldn't that mean there would be little to no...

Thanks!