Recent content by studebaker

  1. S

    Have some questions on a single post floor lift

    Reading thru this posts, did the lift ever get resolved? I have a type A lift I am working on now. Changed out the seal and gland. It has been a great lift for many years and was used when I got it.
  2. S

    Removing an old inground car lift

    I am working on a very old still working Rotary single post in-ground lift. Does anyone know the publication number of this instruction manual?
  3. S

    Snap-On CG-60-4 Narrow Fork

    To complete a steering wheel puller set I just purchased. The CG-60-4 Narrow Fork is missing from the kit. ??
  4. S

    delete

    delete
  5. S

    As promised.......Wilton vise restoration thread.

    Very nicely done! I just did two wilton vises. The first a 450 model and the next a 6400 model. I powder coated the pieces for the 6400 and also high lighted the letters like you did. The pins you have don't match the ones in either of these. Your vise pins look like nails that have been cut...
  6. S

    FS: Papco 600 flaring tool

    Just bought one to do 1/8" line flares. However, the two die blocks have only 3/8-1/2 -5/8-and 3/4 stamped on them. I don't see how you can flair anything smaller. Maybe supposed to be two more die blocks for the other 4 sizes? ??
See more
Top Bottom