Recent content by Stupendous

Here are the oak cabinets my dad and I made. The frame is 2.5" x 3/4" oak with a 1/4" oak panel. Used a table saw and dado blade to basically do it like this. The only issue we had was when we made the bottom doors we overtightened the clamps too much and put a little twist to a couple of the...

I just finished building mine. My workbench is 36" like a kitchen but I made the upper cabinets (12" depth) 24" instead of 16" from the top of the countertop. If you put the wall cabinets too high you won't even be able to reach the bottom shelf without a stepping stool.

My full size truck leaves 24". With the workbench extended along the back wall you wouldn't be able to get to the 3rd car unless you climbed over the truck.

I'm going to be building cabinets and countertop in the 3rd car part of my 3 car garage. The problem is I only have 6 inches from the wall to garage opening in the 3rd car. If I extend my 24" depth countertop down the side I limit the ability to get a car in the 3rd car part of my garage...