Recent content by SVE Performance

Try looking at a"B" size battery it is larger than a "AA" but smaller than a "C" .

Yes I have some Scotch Rack .They went out of business a few years ago so you cannot get replacement parts.

That looks like a pneumatic vacuum that they were using for removing used coolant from machines

You could call them they are still in business. But if it was my grinder I would use a light spindle oil like Mobil velocite 10 which is a 5 weight oil, any thing heavier may cause the bearings to overheat. Bill

maxumhardware.com

Lathe is an American tool works lathe. Bill

Hill Clark and Co are the machinery dealer that sold the lathe not the maker.

A 1YC is not only truck brake compressor those compressor heads were used on electric compressors I have a 3YC in my shop. You need to check that the motor is sized correctly and the pulley is the correct size . Bill

Have the same compressor the valves need to be lapped back in as I had the same problem and that is what fixed it .Parts are still available in the aftermarket including the filter material. Bill

Go to Grobet USA. Bill

If you have a local NAPA that you will be getting parts from then use their Prolink . It has a basic service writer program with labor hours based on Mitchell. Bill

Simple reverse the lift arms when you are going to back into the lift do it all the time . Bill

Yes that is the one . It will cut a countersink concentric to the hole . Yes it only cuts on one side and will not chatter. Bill

That Pinto should give you 21 mpg easy . My parents had a 76 and Mom got hit in the rear on the parkway no fire . In fact the car was repaired and we drove it for years .

Been working out of a Matco box these last 20 years I have never had a single problem with it. Bill