Recent content by swyman

I have the newer control but is not hooked up to come on when humidity is low. Now that I think about it I cannot just run the fan because I have a large water to air coil after the A coil and use a coal boiler for primary heat. I have 2 thermostats, one runs the furnace normally and the other...

This could be an issue. When the furnace was installed we did oversize it because I knew I would be adding on. Since installation I have added 420sqft and am almost finished with another 520. That should definitely add to my cycle times.

Thanks Larry, that makes sense. I do have the hot water line hooked up but will move unit to the hot side and I might get lucky and have the humidifier hooked to run off the fan now, will have to check. Anyone have the steam version?

Search didn't give me the results for my issue.....I cannot get enough moisture in my house during the winter, lots of static! I have a forced air system with a Aprilaire 700 power whole house humidifier (evaporation style) mounted on the return just before the filter. I had a ducted version...

Just an update.... I decided to purchase the Hyperikon 8' LED 5k tubes from amazon. So far I have replaced half of the 96 bulbs and it is amazing! I actually have a shadow under my weld table! Can't wait to get them all done!

So with the direction of members here turning me on to these Hyperikon 8' T12 replacement LED bulbs for my existing fixtures I have a new dilemma.....Frosted or clear, which would work better? My shop is 50x100x16. I have 48 8' T12 fixtures. Out of the 48 I have 19 with bad ballasts so I am...

Installed 5 Utilitech floods from Lowes in the kitchen and have had to replace 4 in a little over a years time. Have been replacing with GE LED floods and so far so good.

7 NO WAY! I just sold my Central Boiler last year......don't get me wrong, it worked great but it consumed way to much of my time to keep it fed. I sold it to my BIL and bought a coal boiler to replace it and that has worked out wonderfully!

A few years ago my friend who has works in the commercial HVAC field brought me the 2.5 nozzles as the one we took out was a 3.0 but we did not make any changes to pressure??? Maybe we should have? I think now from the advice from the members I am looking at Clean Burn heaters. It would be great...

Yes I have thought about getting a custom tarp made through a Tarp Stop which does tarps for Semi's. They quoted me around $600 a couple years ago. Only problem is I have been doing a lot of fabrication work which my saw and steel rack are in the back end. With the car lift in the North/front...

Really couldn't use a boiler as I'm not in there everyday so I would want to pay to keep the water hot while not in use. I went to Blissfield high also but graduated from Deerfield. Class of '91!

The exhaust is power vented through the lower front of the unit and there is a 50' 12" stack outside.