Recent content by tackesp

I believe this set is likely 70-90's as the previous owner is in his early 90's and has hung up the wrenches. He was an over the road driver and race car driver. So I think these are pre- Apex. Wondering if Walden utilized catalogs into this time period? Also, wondered if Walden was carried by a...

Thank you, Have you any suggestions where one might research these?

Hello once again, Finally got around to getting some photos of this group of Walden 3/4 inch drive heavy duty sockets. I have gap at 1 3/16th" ( 50 P 38) with the range being 1" - 1 1/2". They make no mention of Worcester on them so it leads me to believe they are not real old timers. As beefy...

Thanks to all you sleuths. You guys are top rate historians with engine grease under your finger nails. Now I have to go and find a table big enough to lay out all those Craftsman I have collected dating back to the early 50's and further.

Just found this site. Have been reading Alloy Artifacts. They list "modern era" sockets but can't find the set I have. It might be too new for them. It is a beefy 3/4 drive set( 1- 1 1/2) with nothing other than Walden, an equal sign on either end of the socket number, and a socket ID beginning...