Recent content by TBoone

I'd say it is possible.

I misread, I agree. I would not make that commute from that far south. Yes Tolt Hill road did close as it does most any time there is flooding. That is the quickest route to Redmond. When that happens I either drive Carnation Farm road or down to Fall City. Either option is about 5 minutes...

I live in Carnation, 20 minutes to MS/Redmond, same to issaquah. The valley does flood, that said only once in 8 years was I not able to get to work. Several times I have had to go the "long way around" which is 5 minutes longer. My point is it's not all that bad, do your research. There are...

I've had good luck with simply using a shop vac and a screwdriver or pick to get the debris out.

I am and have been for several years running drop in anchors for my tubing bender. I have the same situation as you it sounds like. I have bent manually thousands of bends without the inserts loosening. I use the inserts that use 1/2" bolts. Could see them loosening but have not experienced...

Thanks! That's what I was afraid of, looks like some ductwork is in order... I would like to reduce the layer of **** on everything to make an attempt of keeping things clean.

Good idea! I will have to do some CL searching.

I found this site which lists general calculations: http://www.industrialfansdirect.com/CFM.html And looks like 500 up to 1300 CFM is what I should be looking at so I also found this variable speed fan: http://www.industrialfansdirect.com/IND-FA-EF-GP/LFI-XF12.html Price is decent and fan is...

Currently the far wall of my garage has 2x4 framed shelves with legs to the floor supporting the outer portion and tied into the studs at the back. This structure is 16'long and has 3 shelves all the way across, the lowest being apx. 36" from the floor. I am looking to remove the legs to...

This!:thumbup:

That is the look I am after. Still looking for durability feedback if anyone has it though. I will have to post up a thread once I get back to work on the garage instead of stuff inside it, so April possibly.

Looking for any advice I can get to aid in purchasing/installing a ventilation fan in my 22x22 garage I use as a fabrication shop. I am primarily looking to vent out abrasive wheel dust, welding fumes and sometimes painting fumes. I have no primary work location within the space so I assume a...

Thanks! That seems just like what I am looking for. Any feedback on durability?

I am interested in staining and coating my floor similar to what stores like Fred Meyer or other stores have done to stain and then coat their slab floors. I have searched but not sure I have found what I am looking for. This seems like the best option for me as I have epoxy painted (grey)...

Re: what did you do in your garage today? Wired in my new Fahrenheat 5k heater and am impressed how evenly it raised and sustained temp. Now to finish insulating and drywalling.