Recent content by terdybukrat

  1. T

    What did you do "IN" your garage today?

    Changed engine oil & filter, hydraulic oil & filter air filter & fuel filter on my Kubota b2400…LOTS of oil dry still on the floor
  2. T

    Well, that was dumb…

    So it is not pressed on then. I think my best move will be take all of the buy another and swap parts suggestions to make my FIL’s ratchet whole again. Once that happens it will not be used, but “honored” along with some of my fathers’ tools in a little shop display above my toolbox. Just...
  3. T

    Well, that was dumb…

    Wow! I dint see any keyway... to keep it from spinning, but is the gear pressed on?
  4. T

    Well, that was dumb…

    I posted too soon. Finally got it to move and then it came apart... Now to clean them up.
  5. T

    Well, that was dumb…

    Well, based on the last 15 minutes of attempting to take apart what appeared straight forward, it is obvious that the ratchet is much smarter than i am. I thought that pinching the spring clip/pin would free everything to lift the mechanism out. Iwas wrong. What am i doing wrong? You can...
  6. T

    Well, that was dumb…

    We are out of town visiting family but will do that whenwe get back in town mon/tuesday.
  7. T

    Well, that was dumb…

    Good idea, thanks
  8. T

    Well, that was dumb…

    Ratchet AND kit #’s! Thank you Tools4Me!
  9. T

    Well, that was dumb…

    Wow! That link for the ‘66 catalog is great!
  10. T

    Well, that was dumb…

    Yes, Sir that is 1/2”. I believe Tools4Me has your # in the next response
  11. T

    Well, that was dumb…

    Thank you Tools4Me, I really appreciate it. Based on more reading here you are likely correct that finding a donor might be my best bet. I also came across a link from four.cycle for alloy-artifacts and it has a picture that answers things for me too.
  12. T

    Well, that was dumb…

    I have very few tools from either my father or my father I law, and I just put too much force on it and broke a ratchet that I would love to be able to find repair kit for. I have been going through the Craftsman thread but have not been able to find out what this ratchet # or repair kit #...
  13. T

    I just made a stupid mistake with 18v 1/2” impact

    NUTTSGT i like the spray idea. Thanks to everyone. Since someone asked its a Dewalt and i really want to save it if possible. I’ll try a little of all the suggestions including rice for a couple of day & give her a spin. I’ll let you know how/if it worked out. Thanks again! Sent from my...
  14. T

    I just made a stupid mistake with 18v 1/2” impact

    I appreciate the optimism. I have been kicking my own **** over it Sent from my iPhone using Tapatalk
  15. T

    I just made a stupid mistake with 18v 1/2” impact

    I was in a hurry late yesterday to get tires & wheels off & get them to a tire shop before they closed and didnt realize i left my cordless impact out. Of course it rained really hard for a while last night and i realized my genius move when i got up & looked out the window this morning. Any...
Top Bottom