Recent content by The BrentP

Think I may hold off for a while before getting one, but they're on sale for around half off....or so the advertisement says.

Found a good deal on the IR 3/8" drive Hammerhead and was wondering if anyone has any hands-on with it. Item# IRT2015MAX

Where the hell do you work that GM's buy their techs carts? I barely got my GM to replace the ****** air lines in the shop.

Most of my pliers are Knipex, but I do have a few select SO's for heavy-duty uses. Like the above test, I noticed that my needles were dislodging when pulling cotter pins out of slack adjusters. Considering I pull cotters a lot with most brake jobs, I decided to go with the SO 96CF. I needed a...

Box will be in a permanent place and I'm getting a service cart. I'm planning on using my current CM 26" top chest strictly to load up essentials for road calls. I'm considering pulling the trigger on the Tool Vault combo deal and not looking back. It gives me a little room to buy some quality...

I actually just watched a review on that Tool Vault box. Seriously considering it... being that the combo deal is over $1k off.

So I currently have a little 26" Craftsman top chest that I purchased as a beginner when I first started in heavy duty trucks. Of course, it has only taken a year to completely out grow it. I literally have tools stuffed in this poor little box. I find that as my knowledge in the field...