Recent content by thecrow1

Not sure but it will be high end he referred it to as a food grade? I’m concerned about the gap between the SS and steel moisture salt etc and also can’t use bolts, I have a stick 240 volt so I’ll probably attempt it with one of those rods

Might just buy an aluminum bed next

Any preference on settings on welder

So rock salt is destroying my 1 ton bed on my 3500. I want to weld a stainless steel sheet food grade don’t need it thick just to cover it basically to the bed floor with a 6 inch sides. My setup is a stick welder; would this work and if so any recommendations on settings on the welder, type...

Check this out

I think I may be able to weld short runs w/out the duty cycle cutting me off but we def will see.

Something like this sorry spellcheck got me

Wow I didn’t know that so i should be able to do sun 3/16 , 1/4 steel? I have a bunch of Clovis hooks to weld to my skidsteer bucket what would be the best rod and settings for my machine? If this only runs 45amp I will be golden ty

That sounds good I’m going to give it a try I do have some thicker metal projects I’ll see how it pans out thanks

So I had a flux welder for years served me well. I just bought a 225 titanium stick welder from harbor freight. I have 100 amp service with very few breakers in the service panel, I installed a 240 volt receptacle with 6 gauge wire with a double pole 50 amp breaker. So if I fire the welder up on...