Recent content by TheIceMan

I did mine in black....then I had it redone in gray. Black *****...JMO

My fingers are exactly the same as this drawing. The hold down clamps are just .750" wide pieces of aluminum angle with 5/16 holes in it for a bolt, cut to proper lengths. They're very simple.

I can check mine against Kevin54's drawing too... if needed.

This is one of the nicest builds on here to date! WOW!

I have 4 boxes on each circuit (4 outlets at each box) with that size wire on each circuit. Boxes are every 6' apart.

plasmacam.com .... we have 1 of these at my work. Don't know how much they cost though.

Ditto! .063 or .080 thickness works great.

I wish that I'd have known about that before my concrete was done too.

oh..............my................gawd!:willy_nil :beer:

I thought I was the only one who did that. :lol_hitti :thumbup:

Save your $$ up for the BP lift and skip the epoxy floor. If I had my shop to do over again... I'd probably not do the epoxy floor. Just my $.02

Thank you very much! Your explanation cleared up my mistake. I'm a *******....:lol_hitti My lift now goes up.....and tmrw it will be able to go back down after I get the air lines hooked up for the safety locks.

hmmm....guess I better be calling an electrician then. I would've thought that with the electric cord only having 3 wires I could handle wiring this thing up..apparently not. 2 of the wires are twisted together from the factory (blue and black) which I was told are the hot and that the yellow...

month late here but.......... I just got 1 yesterday. If I could get the thing to work, I'd probably love it. I hooked up the electrical today and the motor won't work. A call to G.S.E. & still no success. I don't have the air locks hooked up yet and I'm wondering if that's my problem (guy at...

Those are cool!