Recent content by TheShafro

Did you design everything from scratch or are the STL's floating on thingiverse, etc? If the former, what are the pattern dimensions? Is it 3.5mm on a 10x10mm pattern?

50% of this thread is literally about all the eBay listings.

Got mine today. They were supposed to arrive tomorrow, but came early.

Just buy whichever is around $100 and pay with your CC thru PayPal (I personally use my bank account). Worst case if PayPal doesn't pay you back, you can call your bank and file a chargeback.

I already ordered two off eBay lol

Went to HFT to replace a ratchet and found them. They definitely weren't there last week

Okay, so just received 2 shipping emails from FedEx and both jacks have been picked up and will be here on Wed 11/09. Two separate tracking numbers and the timestamps on each are about 18 minutes apart. So it seems like other sellers besides sylsy are legit (using the term loosely) as well. But...

Actually, you can leave feedback for canceled orders.

Ordered from s_sylsy_simqvty at Nov 1, 2016 6:58 PM PDT Received shipping email at Nov 3, 2016 3:49 AM PDT Ordered from janiendouthar-0 at Nov 1, 2016 3:38 PM PDT Still no shipping email.

To everyone that received a tracking number, how long did it take to get one? I ordered one jack 21hrs ago and received the eBay compromise email 19hrs ago I ordered the other one from sylsy 18hrs ago and received the compromise email 1hr ago. But I haven't received any tracking info from either.

Just bought two lol. One for $100 shipped and the other for $94.99 from sylsy. Let's see what happens :bounce: Absolutely don't need them as I already have two and a Rotary; but I know I'll kick myself if these become NLA

Yeah, I think that'll be the most cost-effective way. And the funnest! Will take some time tho, so I'll update this thread slowly. Thanks Larry. So those are the feet, but isn't there a part that threads into them and is also welded or bolted into the feet of the stand? That's a good idea, but...

Actually yes, I'm still a beginner welder and I'm always happy to build equipment. I made my own wheel/tire racks and some storage carts, so I was thinking about just making my own since the cost for the Atlas ones is about the same as a used 4 post lift. The only thing I'm not sure about are...

Here's the full blown picture: https://farm3.staticflickr.com/2835/13384792745_40d4fabff8_o.jpg There's a small red plaque on the stands, but nothing that I can make out.

Actually, I would only like to use these to tighten specific suspension bushings that need to be torqued under load. Also when adjusting the height of coilovers, these make it so that I wouldn't have to lower the car all the way to floor then back up again, etc. Thanks for the answer Zeke...