Recent content by Thor01

Unfortunately the area that I screwed up will hold the right side of my Tundra truck, so if it does not fully cure, I am sure the tires will pull it up. Talked to Epoxy Coat today again and they continue to reassure me that it will harden. I'll hope for the best because getting that stuff up...

George, Thank you for your input. I don't know why Epoxy Coat is telling me it will harden based on its current state as that does not compute with my experiences with improperly mixed epoxy glues. They told me that as long as it is not wet to the touch (paint comes off the floor onto your...

Hopefully I am not the only person that has to deal with this mistake, so I am hoping that someone can share their experience with me. I dumped a batch of Epoxy Coat on the floor that had too much Part A (paint) for the amount of Part B (hardener), approximately 15% too much. Before spreading...

Thank you for that reply. It is the best comprehensive, yet understandable explanation I have have on this subject. I am assuming that your Bond Tite 1101, LiquaTile 1184, and EnduraShield 2254 are the three products you are refering to in the explanation above.

I forgot to mention one thing about my garages that may impact what is best for me. The garage floor concrete extends about 12 inches outside of my garage doors before an expansion joint separates it from the brushed pebble surface driveway. This area gets a lot of afternoon sun, so I imagine...

I live at Canyon Lake, TX about 35 miles north of San Antonio. After getting a couple of bids from professionals, and speaking with reps selling DIY kits, I am currently inclined to apply the coating myself for the following reasons. I am pretty much retired, have a lot of time on my hands, am...

I am trying to decide what polyaspartic, cylcoalipatic(like epoxy coat), or other epoxy product to put on my two garage floors, @1300 sq ft total. I have been researching the different products on the markets, have read every post on this forum, and am now more confused than ever. The floors...