Recent content by timm1

I got the westward charger but did not last long. It kept tripping on the breaker in the charger when charging a good battery. I found a wards charger with boost which works well. The model is 61-81061 and it has 50 amp boost and it will charger a battery that is almost dead where the westward...

Now the charger will charge a battery but when it is hooked up when I try to start the mower the charger breaker clicks off still even when I have the charger on boost so I got a used Montgomery wards charger with boost 50 amp which works well. I am trying to find a manual for it the model...

I talked to plp battery supply and they told me I need a breaker which I ordered. They were very helpful.

I have a westward battery charger model 1jyu6b and when I am charging a 12 volt battery the circuit braker keeps clicking on and off.

I think that is for a car. I need one for a tiny tiger ohlsson & rice generator.

I would imagine that service is costly.

I am working on a Ohlsson & rice tiny tiger generator and the stator only puts out 20 volts ac. I would imagine the stator is shot so I am looking for another stator to buy. Thanks.

I canciled the one I bought and purchased a black&decker which works fine but I am missing the stone dresser and the part used to grind the valve stem flat. There is no model on it it just says a645 and I will send pictures maybe someone can tell me more about it to get parts.

I bought a valve grinder and he said it works but he did not know if all the parts are there. Can any one tell if it is missing parts thanks? I will try to send a picture.

Sory I can't see pictures I am blind what was that picture on the last post thanks.

https://www.ebay.com/itm/3872664952

I have a neway gizmatic 3 hand operated valve refacer.

here is the link https://www.ebay.com/itm/387266495284

I was referring to this tool https://www.ebay.com/itm/387266495284

I have a hand valve refacer from newway but a valve had a slight ding in it so I put the valve on a drill press and used a file then I dressed it with my hand newway valve tool.