Recent content by tj675

Picked up a few more things for the assembly table build. The butcher block tops have arrived and a Sjoberg vise showed up as well. Added another light over the location of the future table.

My floor has two levels and this table will sit on the edge of the two. Depending on which side you are standing, there will be a 10” difference in height so it does give some flexibility. I will be using the bottom for storage (drawers and doors). The downside to the different levels is...

I picked up two 30” x 120” x 1.75” maple workbench tops that I will join down the middle. After that is done I might add a few pieces of steel C channel to keep things flat in the future. Definitely going to add dog holes and a Sjoberg vise to one corner.

I put this in the Woodworking forum and will add it here as well. Looking for input and ideas for an a dedicated assembly table. I’ve been using my outfeed table however its length was restricting the assembly of bigger projects. I have a nice hand tool workbench so this will be used for prep...

Thank You Thank You

Oh that’s very nice!!

Looking for input and ideas for an a dedicated assembly table. I’ve been using my outfeed table however its length was restricting the assembly of bigger projects. I have a nice hand tool workbench so this will be used for prep and assembly of projects. Maximum size: 5’x 10’ Top material...

Jon, You guys doing ok with the storms that came through today?

Good to see you posting again Bob!

This plywood was marked from Columbia in Canada. These two pieces were from two different sheets, same bunk. 1/8” twist over 30”

Don’t get me wrong I spent some time going through the bunk and the veneer was really nice. My issues came when breaking the sheets down, the amount and size of the voids in the plywood was the problem. One panel had a 12” x 3” void in the center layer and another panel delaminated when I...

Thank You Thank You

Mom asked that I make her a new TV cabinet last year and it finally made it to the top of the list. Started with some maple plywood and built a quick bottom case. The HD plywood is junk however I was too lazy to drive two hours to get a quality product. Added some maple trim and drawer...

First snowy morning of the season.

Thank you!