Recent content by Tjaltz

I think it’s original to the machine. 18 inches long 3/8” bar stock with some bends.

I put a 1/4” ball valve on my air inlet, so I could control how fast the cylinder fills and the bead breaking speed. Once I disconnect my airline and open the ball valve, it empties in a few seconds.

That’s Interesting, thank you. I figured out that the lever on the right side should be up to break the top bead, and down to break the bottom bead with the upper arm resting on the rim so it doesn’t move. My machine does not have the pull out stop shown in image 4. I’m also finding that it’s...

I have an old Bishman air/electric tire machine, which I believe is a Model 880, and I have a question regarding a lever on it. On the back right of the machine there is a lever that moves 90 degrees. It is either horizontal in one position, or pointing down in the other position. See photos...

Thank you all for the information. It's very helpful.

I am installing a Hot Dawg 45K propane heater in a 2 car garage, at a height of 10 feet. I want to vent the unit out a rear wall (sheetrock, insulation, OSB and vinyl siding). If I am reading the Modine manual correctly, a horizontal vent with a power exhauster (positive vent pressure) is a...