Recent content by tkrum5

This is what i used for mine. This is also what my house was feed with. I purchased a tee, cut the main line to the house, heated it up a little slid the tee on while it was still a little warm and used three ss clamps. Our building inspector said i did not even need the clamps. The larger PVC...

Did not see any answers for these 4 questions. Can anyone help out here?

What do you seal it with so water does not get between the seams?

Great work, Can't wait to see it back in the car.

Did you seal or wax your floor? How do you keep dirt/ water out of the seams?

When I had mine built I asked for vertical studs so It could be insulated. For your now I think I would go with the p200. Will you be covering it with something or sheet rocking it?

This one i built to roll around where every i want. The top is old bowling alley floor.

It all passed our local codes.

I had an 85k btu installed in my garage. I had the open ditch they did the rest. I did pick one that had outside air for combustion. This way I did not have to worry as much, with what I was doing in the shop. I also installed two fans in the ceiling due to the 14 foot height. Ditch has gas...

I have used them on my older BMW's. I have found they do just as good as if i pulled the plug. I read in the instructions that you cannot use them on all cars, due to some have baffles that do not allow you to get to the bottom of the oil pan.

Nice shop Kevin I have the same door stop.

Wow, this looks sweet. What kind of cars are you going to keep in it?

The space is set up for a restroom. But not complete as of yet.

That space was less then the 24 inches. It was the only stuff the had with them

It's a family garage space for everything. But mostly for me.