Recent content by Tlag

One of the double connections to a single breaker is for a doorbell transformer that is bolted to the bottom of the panel. That does not seem like a concern. The other one controls 5 duplex wall receptacles, as far as I know. I'm going to have to disconnect each of the two wires one at a time...

Now that I have the cover off. It looks like there may be a couple breakers that aren't even used. The tandem 15 at the bottom looks like only one side is wired. And it looks like a couple of the singles above it aren't used either. Hmmm. Am I reading that right?

Thanks Dennis, Mine is not so bad as yours was. It is mounted on plywood, just a little hard to see at the angle the photo is taken.

The Gould ITE Pushmatic Load Center was installed in April of 1982 when the house was built. I think it is 200 Amp, but I'm not sure. It still has some space to add some more breakers. I just finished framing a room in the basement and thought I would pull a new circuit there. I found some...

Re: suggestion on how best to paint metal file cabinets?f my media blast cabinets with a 4 inch foam cabinet roller, using an oil based industrial enamel from Sherwin Williams. This thread below will give you a look. A product known as Penetrol is an additive that will make the oil or alkyd...

Some more photos

Another photo

Here is a close-up of one. May be willing to separate some items if you see something you like.

I am reminded of "Dumb & Dumber" when Jim ask the girl what his chances are with her. She says "A million to one." I'm already doing the math on gas and milage.:)

Slip on over to U-Haul, pick up a truck and tell the little woman you're heading out to see the fall foliage in PA and OH. :)

Vintage Welding Goggles. Check out my other listings too. I'm not sure if anyone wears these anymore, but they look cool, maybe collectables? Asking $30 OBO for all three, you pay shipping, or pick them up in Central Ohio. PM me if you are interested.

More from Scott's dad's garage, check out other listings. Here is a set of 3 parts boxes with a lot of nice fittings and hardware. The box drawers are fairly thin metal and can bend easily. Seems like parts this heavy should be in a more substantial box. The boxes are nice enough, just not...

More stuff from Scott's dad's commercial garage. This cabinet is approximately 17" across, 22.5" tall, and 8" deep. Asking $125 OBO. That price includes the oil seals shown in the photo. You pay actual shipping, or pick up in Central Ohio. PM me if you have an interest.

More stuff from Scott's dad's commercial garage. Check out the other listings. This is test equipment that was piled up in the cabinets he is selling. It is untested, and offered AS-IS. He will take $40 or best offer for the whole lot. You pay actual shipping, or pick it up in Central Ohio...

Vintage Parts or Tool Cabinets with logo, doors, drawers & shelves. Shurhit Ignition Cabinets. Check my other listings in these classifieds. These are floor-standing base cabinets with stacked top cabinets. The one with shelves in the door has a combined top and bottom cabinet dimension of...