Recent content by toadjammer

It has a Denso 10S20F compressor with a splined shaft. And appears to be held on with 1 bolt in the middle. Does it just slip on fairly easily? Or is it pressed on?

It is on my 2003 suburban The air was working fine and the clutch burnt, and am hoping that I can swap out the clutch without evacuating the system.

Can anyone suggest the best removal tool for removing an air conditioning compressor clutch? Thanks Toad

Also look at the dewalt chargers. I have an 18V Dewalt and a 12V B&D and just had to trim one tab off of the B&D battery for it to fit into the deawlt tool and charger.

Yes, they both are still available. Trent

What are the approximate 1" square channels in the panels for?

Who was it that put a step by their garage door to keep rain out?

My mistake, I am actually looking for an emtpy case/center section. This is used to locate a bar so that the end tubes can be welded back on relative to the axle center line. Thus the reason that it can be broken or busted. It just has to have the bearing caps and journals intact.

As the title states I am looking for a 9" ford rear carrier. Actual condition is kind of irrelevvant as I am going to be using it for setting up to shorten housings. I would prefer the larger bearing size. The rest doesn't matter as long as it isn't broken in 2. Please PM me if you have...

Blacknwhitepit, Thank you greatly. I had never noticed that offering before. I will be looking around now to see if it is exactly what will fit my need.

Please identify the maker of this tool box. It looks approximately like what I am looking for in a workbench/toolstorage combination.

Where did you find thes custom boxes?

I am need of some special roller chain and the first obvious place, the local farm supply doesn't have any and Mcmaster doesn't have it best I can tell and Grainger wasn't easily navigable. The chain looks like a standard single row 60 series chain but the rollers are .331dia. instead of the...

Another site that I frequent requires a general location to maintain membership. Let's face the fact that there are people from all over the world that access this site with differences in dialect, word and spelling use. It helps tremendously when helping someone with a problem or purchasing...

Ok more lift issues. As I said earlier the lift is used. And with that the chains that run from post to post have coroded. Today I took some of it off to get the correct sizing. In doing so I found out that the rollers are a different size than standard. The rollers measure .331 and the...