Recent content by Toadman!

Nice, thanks. I'll look into that. I would hate for it go down in the middle of spraying the last coat of clear on a vehicle.

I'll prob do the same, I just want a different brand. But another one of the same would be a direct fit. Just irritating.

Hello all. I have a Speedaire 4ZK99 "piggyback" style regulator. It's only a little over a year old. I have filters and dryers before and after the regulator. It started making a noise like a horn, bleeding air out of the hole on the side, and wouldn't regulate, the pressure would just...

That sounds good, I don't paint all that much anyhow. I did some youtubing and there's some good ideas for booths. Thanks to all..

Well, it's 20 years old now. Insulation still works and looks pretty good. Just very very small particles coming off. When I'm not trying to paint I can't even tell anything is coming off it's so small. But in wet paint, especially dark colors it shows up like a diamond in a goats rear.

I thought about putting up some sticky plastic. I just wonder in the heat (100+) would the glue let go and it come falling down later on. IDK.

Thanks for all your replies and info. Sorry for the delayed response. I don't have the chicken wire, just the white vinyl or plastic or whatever it is. Chicken wire would still let the tiny pieces fall through. The pieces I see land on vehicles are tiny specs, hard to see but there. It...

Hello, I'm new here and hope I posted this in the correct place. I have a 30x30 ft metal shop in north Texas. The building was built in 2002 and has the insulation that comes in rolls and was draped over the metal frame before the skin was put on. It looks like while vinyl inside. I paint...