Recent content by Toneloc

I'd like to go 100 AMP. I see # 3 copper is good for 100AMP @ 75C. I was thinking 3-3-3-5 copper SER, which is 0.9" in diameter, so thinking this will be fishable through the 2x4 studding with too big of a hole.

Also...I'm seeing confusing info, but what size aluminum or copper would I need for a run of less than 50'? Would prefer to run inside the wall studs, which are 2x4.

Thanks guys. Found I can't post a picture without 5 posts. This is a basic 28x28 - 2 stall garage. I'm thinking to locate the panel in between the garage doors. Does this seem like a good location for the panel? Reason why.... 1) I was thinking right below the panel in that location would...

Having a little analysis paralysis on updates to my attached garage. :) I'm getting ready to wire and insulate/drywall. Trying to future proof as much as possible. Thinking of putting a subpanel in the garage rather than running the wires from the basement. Since I have the studs...

I just bought a house that has a 28 x 28 attached garage w/ 10' ceilings. Going to be insulating and putting up dry wall on the side walls and want to upgrade the lighting. Right now only has one row of lights across the middle. I think I can modify your 24 x 28 layout for my use....good...