tool_scrounge's latest activity
-
Ttool_scrounge replied to the thread Wilton C1 vs. Tradesman 1765.My experience with cast metal and molded plastic parts is if you are making parts in Asia, having your own employees in country...
-
Ttool_scrounge replied to the thread The VINTAGE toolboxes of Garage Journal!.Nice find! I see them in So Cal for around $250 but they are never in that nice of condition. For some unknown reason, that model is...
-
Ttool_scrounge reacted to Chuckster in NJ's post in the thread Amazon Deals on New Retail Items - Post them! with
Like.
WHITE 3M Tape. Another WOOT deal…….. This is a "CSOB deal" so grab a roll or two. :rocker... -
Ttool_scrounge replied to the thread How can I remove this rust from my jointer top?.I use a NEW razor blade with very thin oil to start. Used razor blades can have small nicks and scratch the surface.
-
Ttool_scrounge reacted to gamescastspencer's post in the thread How can I remove this rust from my jointer top? with Like.
Fresh Razor blade to scrape most of the rust off, then maroon scotch brite. Clean with solvent of some kind, then apply and buff a thin...
-
TThe newest member of the family, Wriggly! 10 week old little girl and accurately named - she's wiggly happy all the time. She is my...
-
TMolly the Cat, holding down the workbench.
-
Ttool_scrounge reacted to Shiftless's post in the thread Tool haul a scrapper finds in a dumpster... with Like.
I’m not scrapper by any means, but I did pull this Reed vise out of a dumpster. My mailman knew I collected bench vises and he was nice...
-
Ttool_scrounge reacted to Mike65's post in the thread A bit off topic.. Fake Rocks for well heads? with Like.
At a previous house my wife & I & my wife's mom lived at the well head was in the middle of the front lawn & bugged my MIL no end. We...
-
Ttool_scrounge replied to the thread Ideas for Outdoor bench and vise setup..Find a vintage cast iron machinery base for cheap. I knew a scrap dealer who found an old overhead pin router cast iron machine base...
-
-
Ttool_scrounge replied to the thread Removing metal caster sockets from a Snap-on tool cart.I thought about tack welding the locking disks to the center socket to keep it from spinning, but I sold my old monster Lincoln 300A...
